rotary table chuck adapter plate supplier

6" base adapter plate is ideal to use on 6" rotary tables of either 3 or 4 slots to mount either 4" , 5" 3-jaw ,6-jaw or 4-jaw self-centering lathe chucks.

•Fully Machined Adapters for Rotary Tables •Standard: For fixturing and mounting 3- & 4-jaw lathe chucks (above). Set Tru: For 3-, 4- & 6-Jaw Set Tru chucks

Remove the 4 cap screws around the outside. Slide the special T-slot nuts into the T-slots on the rotary table. Set the chuck and adapter over the T-slot nuts and reinsert the cap screws. The adapter is registered by the boss that extends from the bottom of the adapter. Tighten the 4 cap screws evenly.

Now you can attach a 1/4″ or 3/8″ drill chuck, an older Unimat chuck with 12 x 1 mm or 14 x 1 mm threads or a 1/2-20 Sears chuck to your Sherline rotary table. The adapter screws into the 3/8-16 threaded center hole of the table.

The chuck adapter has a 15/32 through-hole with 3/4-16 thread for the chuck and a 5/8-24 thread for the rotary table. The through hole allows stock to pass through the chuck and P/N 3710 4″ Rotary Table.

Home / Rotary Tables, Rapid Indexers and Dividing Heads / SCT Rotary Tables / New 100mm 3 Jaw Chuck and Mounting Plate to Suit Soba 6 and 8 inch HV6/8 Rotary Tables