wire rope locking mechanism free sample

nVent products shall be installed and used only as indicated in nVent"s product instruction sheets and training materials. Instruction sheets are available at www.nvent.com and from your nVent customer service representative. Improper installation, misuse, misapplication or other failure to completely follow nVent"s instructions and warnings may cause product malfunction, property damage, serious bodily injury and death and/or void your warranty.

wire rope locking mechanism free sample

Contractors use wire support systems because they are effective and easy to install. Although many different factors and features make some systems better for different applications, all wire rope support systems are comprised of the same basic components.

The wire rope is the cable with which the application is attached to the structural attachment. Different types of wire ropes are used for different load ratings. Common sizes include 1.5 mm, 2 mm and 3 mm. Because the cable is comprised of several strands of steel wire, it has a very high strength-to-weight ratio. As with all applications, product-specific materials should be consulted for the specific limitations of the system.

The locking device is the piece of hardware that holds the wire loop in place. Locking devices may look or install differently based on the manufacturer. Some locking devices are sold with small tools called “keys” that lock up or free the cable. Other locking devices may be keyless and simply require a manual manipulation to move the cable through it. Much like the cable, locking devices are limited to a specific load requirement. The load rating can be different than that of the cable, and installers should default to the lower of the two.

Inside the locking device, the wire is gripped with one or two spring-loaded cams that hold the wire in place. A single-cam device holds the wire by pressing it into the inside wall of the housing. A double-cam device holds the wire by clamping it between two spring-loaded cams. Double-cam devices generally have a stronger grip on the wire than single-cam devices.

End fittings are the hardware at the end of the wire rope made for a specific application. Some examples of end fittings include angle brackets, shot-fire pin brackets and hammer-on flange clips. When used in the correct setting, end fittings can install quickly and provide a secure attachment to almost any structure.

wire rope locking mechanism free sample

• ALWAYS CONFIRM ENGAGEMENT OF CABLE LOCK ON WIRE BEFORE APPLYING THE LOAD:By pushing the adjustment pin in the opposite direction of the arrows on the cable lock and then pulling the cable also in the opposite direction of the arrows on the cable lock.

• PULL ADJUSTMENT PIN BACK AND PASS WIRE ROPE THROUGH KWIK-LOC:Failure to pull adjustment pin first may cause damage to serrated teeth and reduce holding capacity.

• WORKING LOAD LIMIT (WLL) MUST FALL WITHIN THE STATED WORKING LOAD RANGE OF THE CABLE LOCK:Each product is load rated and incorporates a minimum safety factor of 5:1. This WLL takes into account the specification criteria of the Rize Cable Lock and the wire rope.

• When installing Rize cable attachments: to buildings or equipment careful consideration must be made to the attachment method and the material being attached to. It is the responsibility of the installer for the proper selection, installation and appropriateness of the attachment to the job specifications and any codes. Rize can give general guidance, but any questions regarding this should ultimately be directed to the project engineer of the job.

wire rope locking mechanism free sample

Fast and easy way to form a loop with bare cable (sold separately) to suspend lightweight signs and fixtures vertically or at slight angles. Smaller and less expensive option as compared to our 1/32" K-Rize Cable Adjusters. "Bullet" shaped jacket contains an integrated wedge and spring that acts as both a cable release and a locking mechanism for easy height adjustments. Warning: Use only on bare cable (wire rope) in dry, indoor locations. Do not use on coated cable. Suspension of objects at angles reduces the safe working load limits.No special tools or setting keys required