raymarine type 1 hydraulic pump manual factory

Boats with traditional hydraulic steering systems will use an Evolution autopilot driven by a hydraulic pump. The pump connects to the boat"s hydraulic steering lines and allow the autopilot to steer the boat by controlling the flow of fluid through the boat"s steering system. The hydraulic pump is controlled by the Evolution autopilot Actuator Control Unit (ACU.)

We are an Alberta based company that loves our toys as much as you do. We have been in your position before, searching for hours on end looking for that perfect aftermarket solution that fits your budget but doesn"t sacrifice the products quality. We get it and that is where we come in! Doing the research for you. We only carry products that we would install on our own machines. If we wouldn"t trust the parts and products we sell, then we couldn"t expect you to trust them either. We are dedicated to our customers. We work tirelessly to bring you the best products at the lowest possible prices. We strive for 100% customer satisfaction, priding ourselves on prompt communication and fast shipping.

Distributed by Any reference to Raytheon or RTN in this manual should be interpreted as Raymarine. The names Raytheon and RTN are owned by the Raytheon Company.

Hydraulic Pump Installation Guide Drives covered: M81120 Type 1 Hydraulic Pump 12 V M81119 Type 1 Hydraulic Pump 24 V M81121 Type 2 Hydraulic Pump 12 V M81123 Type 2 Hydraulic Pump 24 V M81122 Type 3 Hydraulic Pump 12 V...

EMC conformance All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. The design and manufacture of Raymarine equipment and...

(also known as the Raymarine reversing hydraulic pump). This product is intended to operate the boat’s steering mechanism as part of a Raymarine autopilot system. It is primarily designed for use on boats with an existing hydraulic steering system. Alternatively, you can use this pump on a boat with mechanical steering in conjunction with a secondary steering ram.

Other information Pump dimensions Type 1 (12 V) and Type 2 pumps Figure 2: Type 1 (12 V) and Type 2 pump dimensions Hydraulic Pump - Installation Guide Type 1 (T1) Type 2 (T2) M81120 (12 V) M81121 (12 V)

Hydraulic Pump - Installation Guide Type 3 pump Figure 3: Type 3 pump dimensions Installation instructions Parts required To install this drive you will need: • Parts supplied: • • • Additional parts: • • • Note: Make sure you have obtained these additional parts before you start installation.

Connect to the course computer. Complete the post-installation checks. 1. EMC installation guidelines All Raymarine equipment and accessories are designed to the best industry standards for use in the recreational marine environment. Their design and manufacture conforms to the appropriate...

• Raymarine specified cables are used. Cutting and rejoining these cables can compromise EMC performance and must be avoided unless doing so is detailed in the installation manual.

Connections to other equipment If your Raymarine equipment is to be connected to other equipment using a cable not supplied by Raymarine, a suppression ferrite MUST always be attached to the cable near to the Raymarine unit. 2. Pump mounting Mount the hydraulic pump: •...

Hydraulic Pump - Installation Guide • Try to keep hydraulic fluid loss to a minimum when installing the pump. This will reduce the time and effort required to bleed the system of trapped air after installation: • • WARNING: Before disconnecting any pipes on pressurized systems, you MUST release the pressure at the reservoir by following the manufacturer’s instructions.

Connect the autopilot pump to the steering system as shown in Figure 5. Reservoir pipe Autopilot pump Figure 5: Autopilot pump location for two line systems Hydraulic Pump - Installation Guide Helm pump Check valve (if required) Ram pipes Steering ram...

Hydraulic Pump - Installation Guide Two line pressurized systems Two line pressurized systems have an external pressurized reservoir. This reduces the possibility of introducing air into the system and reduces any steering ‘sponginess’ caused by pipe expansion. Connect the autopilot pump to the steering system as shown in Figure 6.

Connect the autopilot pump to the steering system as shown in Figure 7. Figure 7: Autopilot pump location for three line systems Helm pump Check valve Reservoir pipe Autopilot pump Hydraulic Pump - Installation Guide Ram pipes Steering ram...

Make sure the power supply is switched off before you make any electrical connections. The hydraulic pump has electrical connections for its motor: a red and a black cable. Note: To meet current EMC legislation, you must NOT untwist the pump cables, and you must NOT remove the suppression ferrite.

M81167) across these pipes (as shown in Figure 9). Connect the bypass valve to the CLUTCH terminals on the course • computer using at least 1.5 mm Hydraulic Pump - Installation Guide Cable gauge (AWG) up to 3 m (10 ft)

Hydraulic Pump - Installation Guide Note: Follow the manufacturer’s instructions for mounting the hydraulic ram and reservoir. Figure 9: Connecting to a secondary steering ram 5. Post-installation check WARNING: Keep clear of moving steering systems at all times. Protect moving parts from access during normal use.

Bleeding the system Bleeding the hydraulic system correctly is one of the most important steps when installing the autopilot hydraulic pump. If there is any air in the system the steering will feel spongy, particularly when you turn the wheel to hardover.

Authorized Service Representatives. If you encounter any difficulties with this product, please contact either your national distributor, or your service representative, or the Raymarine Technical Services Call Center. Refer to the back cover or the Worldwide Distributor List for contact details.

Fax +44 (0)23 9269 4642 www.raymarine.com Raymarine Technical Services Call Center UK: +44 (0)23 9271 4713 or +44 (0)23 9269 3611 ext. 1083 Hydraulic Pump - Installation Guide Raymarine Inc 22 Cotton Road, Suite 280 Nashua NH 03063-4219, USA Telephone +1 603 881 5200 Fax +1 603 864 4756 www.raymarine.com...

To match a Raymarine hydraulic pump to your vessel you need to learn the size (in cubic inches) of the actual hydraulic cylinder ram or rams that are mounted to the Rudder on inboard engine boats or the ram mounted to the drive on outboard engine boats. Your steering system documentation will have this information.

The Drive unit is the part that interfaces with your vessel’s steering system to keep you on the right course. Raymarine has a broad range of drive units to match almost any type of steering system.

Raymarine Evolution Autopilot with p70 control head & ACU-400 T70161 Raymarine Evolution Autopilot with p70s control head & ACU-400,EVI Sensor Care EVO Cabling Kit (suitable for Type 2 & 3 drives) Features: Heavy-duty, 30 Amp output for Type...

Raymarine Evolution Autopilot with p70R control head & ACU-400 T70162 Raymarine Evolution Autopilot with p70Rs control head & ACU-400, EV1 Sensor Core, EV1 Cabling kit (suitable for Type 2 & 3 drives) Features: Heavy-duty, 30 Amp output for...

Raymarine Evolution Autopilot with p70R control head, ACU-200 & Type 1 Hydraulic pump T70157 Evolution Hydraulic Pilot with p70Rs control head, ACU-200, EV1 Sensor Core, EV1 Cabling kit & 1.0 litre 12vdc Hydraulic Pump

Raymarine Evolution Autopilot with p70Rs control head & ACU-200, EV1 Sensor Core, EV1 Cabling kit (suitable for Type 1 drives) T70156 Evolution Autopilot with p70Rs control head & ACU-200, EV1 Sensor Core, EV1 Cabling kit (suitable for Type 1...

Raymarine Evolution Autopilot with p70s control head & ACU-100 (suitable for 0.5L Hydraulic, Wheel & Tillerdrives) T70281 Raymarine Evolution Autopilot with p70s control head & ACU-100, EV1 Sensor Core, EV1 Cabling kit (suitable for 0. 5l Hydraulic,...

Raymarine Evolution Autopilot with p70s control head & ACU-200, EV1 Sensor Core, EV1 Cabling kit (suitable for Type 1 drives) T70155 Evolution Autopilot with p70s control head & ACU-200, EV1 Sensor Core, EV1 Cabling kit (suitable for Type 1...

Raymarine Evolution Autopilot with p70s control head, ACU-200, EV1 Sensor Core, EV1 Cabling kit & Type 1 Mechanical Linear drive T70158 Evolution Autopilot with p70s control head, ACU-200, EV1 Sensor Core, EV1 Cabling kit & Type 1 Mechanical...

Raymarine Evolution Cabling Kit R70160 Evolution Cabling Kit RayMarine R70160 is a SeaTalkng Cable Kit. SeaTalkng is built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. The kit...

Raymarine Evolution Cabling Kit EV-2 R70192 Raymarine Evolution Cabling Kit EV-2 The Evolution EV-2 SeaTalkng cable kit contains 1 x SeaTalkng Power Cable (0. 4m) 2 x DeviceNet / SeaTalkng Adaptor Cable (Female) 2 x SeaTalkng Terminator

Raymarine Evolution DBW Autopilot with p70R control head T70214 Raymarine Evolution DBW Autopilot with p70Rs control head, EV2 Sensor Core, EV2 Cabling kit (direct Volvo IPS /Aquamatic system connection) Raymarine Autopilot - EVOLUTION SYSTEM PACKS -...

Raymarine Evolution DBW Autopilot with p70R control head (suitable for drive by wire steering systems) T70164 Raymarine Evolution DBW Autopilot with p70Rs control head, EV2 Sensor Core, EV2 Cabling kit (suitable for drive by wire steering systems) EV-2...

Raymarine Evolution EV1 Sensor Core E70096 At the centre of every Evolution system is the intelligent EV sensor core, a 9-axis sensor that monitors vessel motion in all three dimensions. The innovative EV sensor core combines advanced solid-state sensors...

Raymarine Evolution EV2 Sensor Core E70097 designed for the latest drive-by-wire steering systems At the centre of every Evolution system is the intelligent EV sensor core, a 9-axis sensor that monitors vessel motion in all three dimensions. The...

Raymarine Evolution Hydraulic Pilot with p70Rs control head, ACU-100 T70154 Raymarine Evolution Hydraulic Pilot with p70Rs control head, ACU-100, EV1 Sensor Core, EV1 Cabling kit & 0. 5 litre 12v Hydraulic Pump Complete Raymarine autopilot system...

Raymarine Evolution Hydraulic Pilot, ACU-100 & 0.5l hydraulic pump T70250 Raymarine Evolution Hydraulic Pilot, ACU-100, EV1 Sensor Core, EV1 Cabling kit & 0. 5l hydraulic pump. Note MFD or autopilot control head is required Raymarine Autopilot -...

Raymarine Evolution Solenoid Autopilot with p70R control head & ACU-300 T70160 Raymarine Evolution Solenoid Autopilot with p70Rs control head & ACU-300, EV1 Sensor Core, EV1 Cabling kit (suitable for Solenoid drives) Features: For vessels with...

Raymarine Evolution Tiller Pilot with p70 control head, ACU-100 & Tiller Drive T70153 Raymarine Evolution Tiller Pilot with p70s control head, ACU-100, EV1 Sensor Core, EV1 Cabling kit & Tiller Drive Complete Raymarine autopilot system with...

Raymarine Evolution Tiller Pilot, ACU-100, EV1 Sensor Core, EV1 Cabling kit & Tiller Drive. Note MFD or autopilot control head is required T70249 Raymarine Evolution Tiller Pilot, ACU-100, EV1 Sensor Core, EV1 Cabling kit & Tiller Drive. Note MFD...

Raymarine Evolution Wheel Pilot with p70s control head, ACU-100 & Wheel Drive T70152 Raymarine Evolution Wheel Pilot with p70s control head, ACU-100, EV1 Sensor Core, EV1 Cabling kit & Wheel Drive Complete Raymarine autopilot system with wheel...

Raymarine Evolution Wheel Pilot, ACU-100 & Wheel Drive T70248 Raymarine Evolution Wheel Pilot, ACU-100 & Wheel Drive Race, cruise or fish - Evolution will take command No fuss, easy to install and robust - the Evolution autopilot combines...

Raymarine Follow-On Tiller Controller for Evolution Autopilots A80532 The Evolution Follow-On Tiller can be installed at bridge wing stations, aft docking stations, or even into the arms of pilothouse helm chairs. The intuitive design lets captains make...

Raymarine p70Rs Autopilot Controller (Rotary) E70329 The new control heads are available in two control styles. The Raymarine p70s autopilot control head is a push-button operation controller designed primarily for sailboats, while the Raymarine p70Rs...

Raymarine p70s Autopilot Controller (Buttons) E70328 The new control heads are available in two control styles. The Raymarine p70s autopilot control head is a push-button operation controller designed primarily for sailboats, while the Raymarine p70Rs...