rear pto hydraulic pump quotation

Chief & PrincePTO Hydraulic Tractor Pumps are for all tractors with power take off with a shaft size 1 3/8 " Dia. 6 - Tooth Shaft 540 R.P.M. 21 Tooth Shaft 1000 RPM

A Chief or Prince PTO Pump can be used to power Log splitter, Backhoe, Landscaping equipment Farm machinery, Hydraulic motors, Front end loader, wood splitter, Fence post driver

PTO drive shaft. No additional gear box required. They feature self-adjusting wear plates that seal off oil leakage and offset any wear or expansion that may occur during the life of pump.. Minimum gear clearance. Made of high tensile aluminum housing, with cast iron end plates.

Prince PTO pumps are specifically designed for PTO drive operation on all sizes of farm tractors. No additional gearbox is required. Pumps are mounted by sliding the internally splined pump onto the PTO shaft and restraining rotation with a torque arm.

2250 PSI MAX PRESSURE. 10 micron filtration required. Reservoir should be at least equal to pump GPM output. Maximum operating temperature 180 deg. F. External relief valve required - maximum setting 2250 PSI.

Hydraulic pumps convert mechanical energy into fluid power energy. All hydraulic pumps are positive displacement which means the outlet flow is sealed from the inlet flow. A small amount of fluid is designed to leak internally to lubricate and cool the internal components of the pump. The only function of the pump is to produce flow in a system. Bailey International, LLC provides a wide range of pumps and accessories including clutch pumps, dump, gear, jaw couplers, mounting brackets, pistons, PTO, vane and two stage pumps.

Power Take Off (PTO) pumps designed for PTO drive operation on tractors. Side and rear port pumps are available. Constructed of cast iron end plates and an aluminum center section. Rated pressure up to 2500 psi. Economical alternative to Price brand PTO pumps.

Prince PTO pumps are specifically designed for PTO drive operation on all sizes of farm tractors. No additional gearbox is required. Pumps are mounted by sliding the internally splined pump onto the PTO splined shaft and restraining rotation with a torque arm. See page P6 for the PTO pump torque arm kit.