sewage mud pump made in china

Sewage pumps are used to transport sewage and untreated wastewater (e.g. raw wastewater). They are most commonly used in municipal sewage treatment plants, but they are also used in buildings and private homes, which cannot be connected to municipal sewers due to the natural slope of the terrain.

Most sewage treatment systems use the force of gravity to move solids and liquids down the pipeline. However, in some cases, it is necessary to pump sewage up from the septic tank to the urban sewage system. In these cases, the sewage pump has become an indispensable equipment for conveying sewage. This type of pump has one job and only one job: conveying solids and liquids between different positions. Generally, the sewage tank must be located in the lowest area where drainage is required. The pump can be submerged in water and may have to handle some fluid at almost any time.

Submersible sewage pumps are located at the bottom of pools or containers, such as septic tanks. Sewage pump became popular in the early 1960s. At that time, a guide rail system was developed to lift the pump out of the pump station for maintenance, and put an end to sending people to dirty and dangerous sewage pits or wet pits. The growth of submersible pumps for sewage pumping is amazing because the designee understands their advantages. The water inlet of the pump shall be as close to the bottom of the pool as possible, usually at or near the bottom of the equipment. The goal is to drain as much solids and liquids as possible from the pool. However, because there must be a certain space between the bottom plate and the pump, it is impossible to completely discharge the sewage without manual intervention.

Most cities use two disconnected sewer systems, rainwater pipes and sewage pipes. Rainwater pipes collect rainwater and other relatively clean water. These sewers have common drainage grids on urban streets. The system contains Street garbage and dirt, but there is no actual domestic sewage. In many cases, cities simply filter the water to remove garbage or waste and allow it to be discharged into local water sources without treatment. Since the water is relatively clean, this usually has no impact on the environment.

Although the pump mainly deals with liquid, it is sometimes necessary to deal with solids in liquid through the system. Most pumps can handle solids up to 2 inches (5 cm) in diameter. Commercial pumps may be able to handle larger items.

Most sewage pumps work in the same way. The floating ball (liquid level switch) is installed on the pump in the same way as the sump pump or even the toilet tank. When the floating ball reaches a certain height, it will start the switch and start the pumping action. When the liquid lowers the floating ball to a certain point, the pump will shut down.

For many residential consumers, the main point is to decide what size pump to buy. They are typically rated at horsepower, mostly between 0.5 HP and 1.0 HP. The size of the pump shall be based on the amount of sewage normally required to be delivered, usually expressed in gallons per hour. In general, domestic sewage pumps can deliver 5500 gallons (20000 liters, about 20 m3) to 8000 gallons (about 30000 liters, about 30 m3) per hour.

Complete production and processing, inspection, testing (pump performance test platform), and other equipment, to ensure that product quality is stable and reliable.

This series pump is widely used for sewage treatment of city construction discharge for architecture projects, hotel, mine, pond, dyeing and printing, paper making and textile industries.

1. The medium temperature should not be over 60oC, the density 1200Kg/m3, and the pH value within 5-9.2. During running, the pump must not be lower than the permitted lowest liquid level.3. Rated voltage 380 V, rated frequency 50 Hz. The motor can run successfully, only under the condition the deviations of both rated voltage and frequency are not over ± 5%.4. The maximum diameter of the solid grain going through the pump has not to be larger than 50% of that of the pump outlet.

Residential & Commercial Application--A great sewage submersible pump for emptying swimming pools, puddles, keeping basements dry, and pumping out sludge and mud. Can also be used for light commercial sewage and dewatering.

Tobee® TPN Sludge Pumpis single stage, single sution, horizontal centrifugal mud sludge pump, this type pump wetted components are made from wear-resistant alloy materials. Impeller and guard board clearance can adjust to maintain efficient work. 6 inches below the pump type with threaded connection, impeller 8 inches above pump type from the key link. Shaft seals use packing seal, work should be injected higher working pressure 1kg/cm2 shaft seal water. The pump has simple structure, reliable, simple maintenance and long service life etc. Suitable for mining conveying solid-liquid two-phase fluid with, conveying maximum weightconcentration for 50-60%.

Junhe Pumps Holding Co., Ltd. stablished in 1999,we,Junhe Pumps Holding co.,Ltd.have been specialized in producing Sewage Pumps for more than 22 years. Our 1500+ working staff and 116,000㎡ factory building are capable of running 4 million pieces of pumps each year, which significantly contributes us to be one of the top professional house hold water pump manufacturers here in China at the time being.

Water pump is the core business of JUNHE enterprise. The leading products are new domestic water pumps, including submersible pump, garden pump, deep well pump and fountain pump, with more than 1000 product models. Sewage Pump is widely used in household water supply, drainage, garden irrigation, household cleaning and beautification. In recent years, the company has gradually established a diversified product series based on domestic water pumps, and actively transformed and upgraded to product systematization and schematization, striving to provide customers and consumers with professional and comprehensive products and services.

Currently, we have five main pump series, and more than 1000 single items are being manufactured in our company comply with GS, CE, EMC ,UL and CSA certificates 100% of Sewage Pumps are exported to Europe, North America, South America, Middle East and Oceania Markets, etc. In daily communication with customers, the company can provide a series of perfect pre-sale, in sale and after-sale services. In the early stage of cooperation, the company"s business personnel will introduce the required products to customers in detail, and recommend the relevant hot products; in the order process, the company"s personnel track the relevant orders, and feed back the customer process at any time; after the end of the order, the goods arrive at the customer smoothly, and the company has relevant colleagues to conduct after-sales satisfaction survey, so as to prepare for the next service.

Customized Sewage Pump made in China can be purchased at right price. Our products are SGS certified. In addition, our products are durable. JUNHE is a famous Sewage Pump manufacturers and suppliers in China. If necessary, we will not only provide price lists but also quotations. If I want to wholesale, what price will you give me? If your wholesale quantity is large, we can provide the reasonable price. You are welcomed to come to our factory to buy the high quality Sewage Pump. We look forward to cooperating with you, if you want to know more, you can consult us now, we will reply to you in time! We are confident to become your long-term partner on the basis of mutual benefit.