rotary table chuck adapter plate quotation

6" base adapter plate is ideal to use on 6" rotary tables of either 3 or 4 slots to mount either 4" , 5" 3-jaw ,6-jaw or 4-jaw self-centering lathe chucks.

Remove the 4 cap screws around the outside. Slide the special T-slot nuts into the T-slots on the rotary table. Set the chuck and adapter over the T-slot nuts and reinsert the cap screws. The adapter is registered by the boss that extends from the bottom of the adapter. Tighten the 4 cap screws evenly.

•Fully Machined Adapters for Rotary Tables •Standard: For fixturing and mounting 3- & 4-jaw lathe chucks (above). Set Tru: For 3-, 4- & 6-Jaw Set Tru chucks