6 inch rotary table factory

The mill rotary table is one of the main accessories of milling machine. As a precision work positioning device, it is widely used for indexing drilling, milling, circumferential cutting, boring, etc. The rotary turn table for milling machine is made from casting with high quality, can work with a set of dividing plate.

Both vertical and horizontal with two functions. Circle cutting, indexing drilling, milling and more complicated work are possible when the vertical position of the table is used together with the tail part.

Three dividing plate set(Plate "A" - 15, 16, 17, 18, 19, 20 Plate "B" - 21, 23, 27, 29, 31, 33 Plate "C" - 37, 39, 41, 43, 47, 49). A set of wrench and screws are free for you with your installation.

WARNING:WARNING: This products contains chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm. ADVERTENCIA: Este producto coniene productos quimcos reconocidos por el estado de California que provocan cáncer, defectos de nacimiento u otros danos reproductivos For more information go tohttps://www.p65warnings.ca.gov/

The H7527 manual was written by our U.S. based Technical Documentation Department and is packed with useful information. The complete and easy-to-read manual makes it easier to assemble and maintain your rotary table.

The Grizzly Customer Service and Technical Support Teams are U.S. based. Parts for the rotary table may be available online and shipped from the Grizzly parts warehouse in Springfield, MO.

This listing features our most popular size of rotary table that we sell. It is from the VERTEX factory in Taiwan and is manufactured to strict specs of high density Meehanite casting. It is inspected by the HEIDENHAIN process and is guaranteed flat and parallel. 4 slots allow for easy mounting of work, or it can also accomodate a 5 inch 3 jaw chuck. Also available are dividing plates and a tail stock . Overall height is 3.11 inches and the unit ships at 28 lbs

This 6" horizontal / vertical rotary table is for indexing, circular cutting, angle setting, boring, and spot facing operations. The cast iron table is precision machined in Taiwan and has a #2 Morse taper center hole. This 6" rotary table is graduated with a 360° scale. A micro collar graduated to one minute with a ten second accuracy vernier scale is provided. This horizontal/vertical rotary table has lock down clamps and the crank can be disengaged.

Vertex 6″ Horizontal/Vertical Rotary Table. Made from high density Meehanite. Hardened and ground worm. 90:1 ratio. 360 degree graduation, one turn of handle moves table through 4 degrees. Microcollar graduated in steps of 2 min, vernier scale makes settings down to 20 seconds possible. 80mm height. 11mm T Slots.