hv6 rotary table in stock

Description: HV6 Rotary Table, Dividing Plate & Tailstock Set Rotary Table Diameter :150 mm (6") Overall Height : 80 mm ( 3-1/4") Centre Height in Vertical Position: 105 mm Worm- Gear Ratio- 1:90, which means that the 1 handle rotation shall turn the table by 4 Degrees. Table Graduated 360 Degrees, Resettable Dial & Handwheel graduated in seconds. Vernier scale is caliberated to 10 seconds. Centre Bore of the Table: 2 MT 2 Oiling Points for a direct lubrication of the Table for longer life & better performance. Can be clamped in Horizontal as well Vertical Position. Supplied with Dividing Plate Set for Indexing & a Tailstock for a total Indexing solution. Safety & Operation manual is also supplied. More Information about the Dividing Plate :- Set of 3 dividing plates designed to fit our HV4 & HV6 Rotary Tables. Centre Hole of the Plate is 21 mm No. of Holes in each Plate Plate A- 15, 16, 17, 18, 19, 20, Plate B- 21, 23, 27, 29, 31, 33 Plate C- 37, 39, 41, 47, 49 It is supplied with a brass stopper key, Bracket, Crank Handle & fixing screws.

1.Our Tables are made of high density Meehanite and use "HEIDENHAIN" electronic equipment to inspect angle to assure the excellent quality and durableness.

3.Worm is hardened and ground. The ratio is 90:1. The work table is graduated a full 360° so that one turn of the handle moves the table through 4°. Micro collar is graduated in steps of 2"min. And vernier scale makes settings down to 10 seconds possible.

4.These Rotary Tables are popular for their excellent performance, practical design and reasonable cost. They are widely used for circular cutting work, angle setting, boring, spot-facing and similar work.

1.Our Tables are made of high density Meehanite and use "HEIDENHAIN" electronic equipment to inspect angle to assure the excellent quality and durableness.

3.Worm is hardened and ground. The ratio is 90:1. The work table is graduated a full 360° so that one turn of the handle moves the table through 4°. Micro collar is graduated in steps of 2"min. And vernier scale makes settings down to 10 seconds possible.

4.These Rotary Tables are popular for their excellent performance, practical design and reasonable cost. They are widely used for circular cutting work, angle setting, boring, spot-facing and similar work.

This listing features our most popular size of rotary table that we sell. It is from the VERTEX factory in Taiwan and is manufactured to strict specs of high density Meehanite casting. It is inspected by the HEIDENHAIN process and is guaranteed flat and parallel. 4 slots allow for easy mounting of work, or it can also accomodate a 5 inch 3 jaw chuck. Also available are dividing plates and a tail stock . Overall height is 3.11 inches and the unit ships at 28 lbs

A rotary table is a precision work positioning device used in metalworking. It enables the operator to drill or cut work at exact intervals around a fixed (usually horizontal or vertical) axis. Some rotary tables allow the use of index plates for indexing operations, and some can also be fitted with dividing plates that enable regular work positioning at divisions for which indexing plates are not available.