ge xl44 safety valve in stock

GE gas range oven safety valve for round ignitors. 3.3 - 4.0 volts. 2.5 - 3.0 amps. Valve has male wire terminals. Reference number 164D2574G001 and 30100-17. ... More Info

GE gas range oven safety valve. This is a dual valve. 1/4" male terminals on top. 3/16" male terminals on bottom. Reference numbers 223C3389G001 and Y30148-14. ... More Info

All, hi.....and new to this blog and hoping we got some experts here that can point me in the right direction.........GE Spectra oven (JGBP30WEA4WW) would not heat but oven igniter would glow as well as broiler igniter( I never did verify if gas erupts when broiler is on). After much research online I determined that the oven igniter was at fault and replaced with with a WB19K14 part. Old igniter measured no resistance, new one measured approx 500 ohms. Replaced it thinking i was done but now the new igniter does not light but the broiler ignitor still lights when selected to that position. top stove burners all light etc., I am somewhat convinced that the new igniter is good because of resistance measurement (i have no amp meter) and am suspecting perhaps the gas valve is suspect because of the dual nature of having separate plug ins for broiler igniter and oven. Also relay kicks in for either position....even after oven igniter replacement (but now does not glow).

question ....can i swap the broiler and oven igniter wires on the gas safety valve to see if the oven side of the valve is bad as we do not use the broiler portion and would not bother to replace valve if a swap of wires on valve fixes the problem. If that cannot be done then I am wondering what the next step is as I replaced the oven igniter that now does not glow and wanting to fix this without shotgunning maintenance to keep cost down of restoring unit. any advice on fixing this would be appreciated as I do not want to have to buy new oven....if I can get this one back in service.

Low voltage, oven safety valve with female wire terminals for a flat ignitor. This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

3/8" Oven safety valve with male wire terminals for a flat ignitor. This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

3/8" inlet Oven safety valve. This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

Dual terminal Oven safety valve. This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

Standard-clean models: jgbs03; jgbs04; jgss05; jgbs07; jgbs15; jgbs17; jgbs20; jgbs21; jgbs22; jgbs23 continuous-clean models: jgbc17; jgbc20; (48 pages)