overshot weaving drafts price

This item is included in the Handwoven Library! View Overshot Pot Holders Weaving Pattern Download and hundreds of other resources included with Handwoven subscriptions.

If overshot intimidates you, these pot holders are a great way to start! Pot holders are a great format for overshot. One pattern repeat fits neatly into a pot holder"s size. Use them to decorate your kitchen- or as a perfect hostess gift. The fun part of weaving is to take an idea, try it out, and then do it your own way!

An old pattern in overshot weaving that has had many names over time: Muscadine Hills, Hickory Leaf, Blooming Leaf. The Double Bow Knot name comes from the leaf like square that forms the larger …

After weaving the project samples for my book, I had a bit of an 8/4 cotton warp remaining on the loom. I perused my stack of Handwoven magazines and saved project files for some inspiration and decided upon weaving a little overshot on this remnant.

For the Non-Weavers - Overshot is a weaving technique. If you are familiar with Colonial coverlets, they were traditionally woven in overshot patterns. Here is a link with great photos Woven American Coverlets.

Unlike Krokbragd, a wealth of information exists on how to weave overshot. Just about any weaving book will contain at least a chapter on the topic, as well as there are videos, articles and countless published drafts.

Back to my little overshot project, I found my inspiration in the November/December 2017 issue of Handwovenin an article by Inga Marie Carmel entitled ‘Exploring Overshot’. The author chose a draft called Blossom, a Bertha Gray Hayes miniature overshot pattern.

Bertha Gray Hayes was an early 20th century weaver known for her miniature overshot and name draft designs. Miniature overshot pares down an established overshot pattern to its bare minimum while still maintaining the integrity of the pattern’s character. For more on the subject, check out Weaving Designs By Bertha Gray Hayes: Miniature Overshot Patterns by Norma Smayda, Gretchen White, Jody Brown, and Katharine Schelleng.

In Ms. Carmel’s sampler, she explored six different treadlings of the Blossom pattern. Since I had a much smaller warp, I had to do a bit of reworking in Weaveit (the weaving software program I use). I was only able to weave three of the six variations; the star and rose which are two of the basic overshot treadlings, and a variation referred to as “in the Scandinavian manner”.

Typical of overshot samplers and coverlets, the motifs are framed by a complementary border. If you compare my left selvedge with the right, you will notice that I did not quite work out the correct border. Although I’m not keen to sample, this certainly is a good example where sampling would be beneficial before committing to weaving the edited draft on a much larger project.

An interesting feature of overshot is that the reverse side is generally also equally attractive. I actually chose this reverse side as the “front” of my project.

I’m not sure how I thought of the investment of time in those coverlets. I loved weaving them. If you loved to ski, would you think you should make money doing it? After a few of them, though, I couldn’t help but realize that from start to finish, coverlets take a very long time. The one that took me the longest probably had close to a thousand hours in it. For that coverlet, I used pick-up to weave corner logos the way professional jacquard coverlet weavers did. My goal was to sell these coverlets, so I had to determine a price for them. At just about this time, in the mid 1980s, Cost Plus was selling doubleweave throws in Jacquard coverlet patterns. Their cost? Under $50. Trying to figure out how much to charge for my coverlets was only the first time I wrestled with the issue of what determines the value of a handwoven item.

Value does not really seem to be related to the number of hours it takes to create something, especially with something handwoven. For an hourly wage, weaving coverlets was clearly a losing proposition. Over the years, I also discovered that as much weaving pleasure can come from weaving something small as from weaving something large. The advantages to weaving small items are almost too many to count: your loom can be small; it can even be a portable table loom. You use a lot less yarn. Warping is much faster. You feel the joy of completion sooner and much more often. A small item is appreciated as much as a large one.

For your next project, start with something small, like overshot pot holders (instead of coverlets!) like those designed by Jean Korus in the May/June 2005 issue of Handwoven.

In its simplest form – overshot is a weaving technique that utilizes at least 2 different types of weft yarns and floats to create a pattern. These patterns are often heavily geometric.

Ground weft– plain weave pattern that is used between each row of your overshot pattern. This plain weave gives the textile structure and allows for large areas of overshot to be woven without creating an overly sleazy fabric. Without the use of a ground weft on an overshot pattern, the weaving would not hold together because there would not be enough warp and weft intersections to create a solid weaving.

They were most popular though in southern Appalachia and continued to be so even after textile technologies advanced. When other parts of colonial America moved to jacquard weaving, the weavers of southern Appalachia continued to weave their overshot coverlets by hand.

Since the overshot coverlets were most often woven at home on smaller looms they usually had a seam down the middle where two woven panels were sewn together.

The thing about overshot is that no matter the application, it is pretty impressive. Perhaps that is just my opinion, but due to how complex it can look, I feel that it is pretty safe to say.

Just because it was originally used for coverlets, does not mean it can only be used for coverlets. Changing aspects of the pattern like the colors used, or the way you use your ground weft can drastically change the look and feel of your weaving.

In the image below you can see the ground weft is not the same color throughout. Instead, I wove the ground weft as discontinuous so that I could add extra pattern and design into the weavings. In this case, you may be wondering how to deal with your weft yarns when they are in the middle of the weaving and not at the selvage.

The discontinuous weft yarns will float onto the back of the weaving until you are ready for them in their next pick. This does make your overshot weaving one sided since it will have vertical floats on the back. Keep this in mind if you want to try this technique out.

Also seen in the image above, the overshot yarn that I used was not all one color! This is a really simple way to get extra dimension and interest in your overshot if that is something you are looking for.

This makes it simple to be able to only weave overshot in certain parts of your weaving. If you want to do this then you can continue to weave your plain weave across the entire width of your weaving, but only weave overshot in specific areas. This creates a overshot section that functions similar to inlay.

Since the overshot pattern is strongly influenced by the weft yarns that are used it is important to choose the right yarns. Your weaving will be set up to the specification needed for a balanced plain weave. Make sure you understand EPI in order to get the right warp sett for your overshot weaving.

The ground weft used is almost always the same yarn as your warp. This allows the overshot weft to really be able to shine without contrasting warp and weft plain weave yarns.

In order to get the full effect of the overshot, it must be thick enough that when you are weaving your pattern it covers up the ground weft between each pass. If it is not thick enough to do this, it will still be overshot, but the full effect will not be seen.

What this warp thread does is serve as an all-purpose selvedge that does not correspond with your pattern. Instead, you would make sure to go around this warp thread every time to make sure that you are able to weave fully to the selvedge. Without this, your overshot weft will float awkwardly on the back of your weaving whenever the pattern does not take it to the edge.

I have mentioned this book multiple times because it really is such a great resource for any weaver looking to weave patterns of all types. It contains 23 pages of different overshot patterns (among so many other patterns) that you can set up on your floor or table loom.

Like a lot of different types of weaving, it is possible to do it on almost any type of loom that you have. The difference being that it might take you a little bit longer or require a bit more effort than if you did it on a traditional floor loom.

Weaving overshot on a frame loom or rigid heddle loom will require the use of string heddles and pick-up sticks that you have to manually use to create a shed.

A project that most weavers have on their lifetime bucket list to weave is the pattern called Lee’s Surrender. Did you know there are a number of patterns that are related to this legendary Overshot motif? Purchasing this package will deliver 60+ draft files in PDF  and .WIF formats, as well as an eBook explaining how the Radiating Overshot motifs Sunrise, Blooming Leaf, Bow Knot and Double Bow Knot are related and how you can customize your own profile drafts to create entirely new patterns. The draft package contains full drafts for historic coverlets, “woven as drawn in drafts”, and profile drafts for more than 20 designs. See historic coverlets come to life in an accessible format for contemporary weavers. The drafts are provided in computer format (.WIF) files which are compatible to most weaving software regardless of platform (OSX, Windows or MAC). And PDF files can be printed out, or viewed on a tablet or computer screen without the need for weaving software. To make it easier to access the files a Radiating Pattern Draft File Catalogue is included with screenshots of the draft files matched to the file names.

In compiling this collection of patterns and the instructions on how to make the drafts, I completed extensive research using historical weaving books, and information available from museums digital collections. There were a number of items that needed to be drafted from photographs. I have shared the sources of my research and the files that I generated along the way.

It is my intention that the reader of this material will not only be equipped to weave the Lee’s Surrender pattern but will also be able to create a unique design of their own using the information they have learned about working with profile drafts.

This is the book a weaver who does not have software should purchase to have access to the Mournin’ Max sampler row drafts. Everything a non-computerized weaver needs is present.

Woven by Rachel SnackWeave two overshot patterns with the same threading using this downloadable weave draft to guide you. This pattern features the original draft along with one pattern variation. Some yarns shown in the draft are available to purchase in our shop: 8/2 cotton, wool singles, 8/4 cotton (comparable to the 8/4 linen shown).

please note: this .pdf does not explain how to read a weaving draft, how to interpret the draft onto the loom, or the nuances of the overshot structure.

This book features the original sample collection and handwritten drafts of the talented, early 20th century weaver, Bertha Gray Hayes of Providence, Rhode Island. She designed and wove miniature overshot patterns for four-harness looms that are creative and unique. The book contains color reproductions of 72 original sample cards and 20 recently discovered patterns, many shown with a picture of the woven sample, and each with computer-generated drawdowns and drafting patterns. Her designs are unique in their asymmetry and personal in her use of name drafting to create the designs. Bertha Hayes attended the first nine National Conferences of American Handweavers (1938-1946). She learned to weave by herself through the Shuttle-Craft home course and was a charter member of the Shuttle-Craft Guild, and authored articles on weaving.

This class is not for absolute beginner floor loom weavers. If you are a beginner, please start with my Introduction to Floor Loom Weaving class for all the basics.

A 4 shaft floor loom with 6 treadles. My floor loom has a 35" weaving width, but if your loom is smaller I have provided an alternative class project.

Kelly is a self taught weaver with a big passion for sharing the timeless art of weaving with others. Kelly is known for her calm and slow teaching style and she bases her classes on how she would have liked to have been taught. She designs all of her own projects and caters for levels from beginner to intermediate. Most available classes are for the rigid heddle loom, floor, table and inkle loom weaving.