side door overshot pricelist

PARVEEN Wireline Overshots are used retrieve a fish lost in the well that does not have a conventional fishing neck or a damaged fishing neck on it. The tool is operated by applying the weight of the tool string on to the fish. This will allow the slips to expand around the fish when the tool string is picked up, the slip will engage the fish. These are non releasable type overshots.

Note: *Cased Hole Only. The Chart above is a guide-line only and should be used as a rule of thumb; the final decision is that of the Customer; 4” Pin-up drill pipe is an option inside 7” casing, discuss

with Fishing Tool Manager for guidance. Consult with a EOFR Fishing Manager when requirements do not fall within the guide line shown; Bottom Hole Assemblies (BHA) also should be considered

* All pull loads listed are based on a magnet engaging a flat surface covering the entire face of the magnet. “Pick up” capability will be reduced considerably

The LB Series design was inspired by great feedback from the knife making community as well as culinary and long-blade makers. Knife makers needed to use the entire length of the chamber without overheating their blades at the back wall. We took a fresh look at our designs and created the side-only heating element LB Series.

Heat treating requires the removing of some very hot material from the chamber in order to quench. Everything in the chamber is hot, which includes the door. The doors on the LB"s swing out and to the side, a full 180° if you need it. This puts the super-heated door well away from you as you concentrate on the work at hand.

The handle/latch on our swing out door is conveniently located at the front of the door, not hidden along the side. This spring loaded, phenolic handle is cool to the touch, is one-handed in design and serves as the door latch as well.

Many thanks to those who have offered feedback on our door handle/latch. We have updated the design to make centering, inserting and all-around operation cleaner and easier!

The switch used for this feature is a true safety switch and is designed specifically for safety applications. Those wishing to enter the oven during use should strongly consider requesting this option as an added measure of safety.