spiral grapple overshot quotation

The internal catch mechanisms have two basic types:a basket grapple and a sprial grapple. of fish to be caught; 3: Size and type of top connection; 4: If size other than standard, please specify clearly, etc. Our Service Objective: People-O riented, Quality firstly and Best service.

Series 150 Overshot consists of three outside parts: Top Sub, Bowl, and Standard Guide. The Basic Overshot may be dressed with either of two sets of internal parts, if the fish diameter is near the maximum catch of the Overshot, a Spiral Grapple, Spiral Grapple Control, and Type “A” Packer are used. If the fish diameter is considerably below maximum catch size (1/2” or more) a Basket Grapple and a Mill Control Packer are used.

Bowen™ Series 150 Releasing and Ciculating Overshots are the industry standard for external catch fishing tools. With a proven track record and the highest quality construction and design, the Series 150 Overshot is the efficient and cost effective tool for fishing companies all over the world.

We have an extensive range of good used or rebuilt Basket or Spiral Grapples along with the packers and controls. Call us for your fishing tool needs at 936-336-5154 or email us at Sales@PickettOilfield.com.

Pickett Oilfield, LLC offers prospective buyers an extensive selection of quality new, used, and refurbished Oil & Gas Drilling Equipment at competitive Market Prices, including basket and spiral Grapples to choose from.

The Coil Solutions Overshots are used to engage and pull a fish from the well bore. It uses a grapple to bite into the outside of the fish and releases by following through a predetermined rate to disengage the grapple. The tool comes with a range of grapples to accommodate various fish sizes.

Release of the grapple is activated by flowing through a predetermined amount. A pressure differential of 700 psi at the tool will initiate the release of the grapple.

The Access Downhole Hydraulic Releasing Overshot was specifically created for situations where releasing the overshot with rotation is not a possibility or outright impossible. Although this was the initial

When certain BHA components are necessary above the overshot, and any one of the components cannot pass a ball, the Hydraulic Releasing Overshot becomes the optimal choice, as it only requires a pressure increase and the occasional downward bump to release.

The main difference the hydraulic Releasing Overshot and standard overshots is that it does not accommodate spiral grapples, which reduces the catch range. However, the Hydraulic Release Overshot accommodates the same types of shoes and overshot accessories as mechanical release overshots.

Typical operating considerations for Hydraulic Overshots include but are not limited to, flushing between runs to remove any treatment fluid, debris, or wellbore fluids that may damage or corrode the seal surfaces in the piston. Disassemble the overshot, replace the screws retaining the grapple, and oil the piston area each run to insure proper operation.

ONE LOT OF ALL THE REQUIRED GRAPPLES (BOTH BASKET AND SPIRAL) WITH GRAPPLE CONTROLS, MILL CONTROL PACKERS, LOCK RING, BREAK OUT CLAMPS AND PACKERS TO SUITE 10”, 8” DRILL COLLARS, DRILL COLLARS AND OTHER TUBULAR IN ABOVE HOLE SIZES.

The releasing and circulating overshot is the fishing tool which is simple, high strength and high reliability and fishing from outside of fishing objects.? ?

The internal catch mechanisms have two basic types: a basket grapple and a spiral grapple. According to different uses, it may be equipped with accessories, such as extension sub, wall hook, oversize guide, etc.