8 vertex rotary table made in china

1.Our Tables are made of high density Meehanite and use "HEIDENHAIN" electronic equipment to inspect angle to assure the excellent quality and durableness.

3.Worm is hardened and ground. The ratio is 90:1. The work table is graduated a full 360° so that one turn of the handle moves the table through 4°. Micro collar is graduated in steps of 1"min. And vernier scale makes settings down to 10 seconds possible.

4.These Rotary Tables are popular for their excellent performance, practical design and reasonable cost. They are widely used for circular cutting work, angle setting, boring, spot-facing and similar work.

I am thinking of adding an 8" horizontal/vertical rotary table to my PM935 mill setup and need some suggestions. The candidates I have seen so far are Yuasa, Vertex, and Phase II. Their are other but these seem to be the most readily available in 8".

It seems the Yuasa (550-048) is supposed to be the best of the lot but very expensive. I believe only MSC sells these new. Ebay will list one from time to time but my concern is I have seen them with 4 slots and 6 slots with the same part number.

Vertex or Accura Vertex seems to be still made in Taiwan. Slot count gets really weird with them when buying new off of ebay. One seller from southern California pictures the unit with six slots, provides an advertisement showing another picture for the unit with six slots and then specs three slots in two other places. Another guy from the east coast sells a four slot version. I am curious is a six slot version even exists for the 8" model.

This listing features the clean, quality VERTEX 8 inch horizontal/vertical rotary table. It is constructed of high density Meehanite and is inspected for quality using the HEIDENHAIN process to guarantee flatness and parallelism. 4 slots allow for easy clamping of the work to the table surface. MT3 center hole , 5/8 t-sloit size. Overall height is 4.13 inches. We also sell a package that includes the tail stock and dividing plates for this. We do sell the tail stock and dividing plates seperately, as well as a 6 inch 3 jaw chuck for this unit.