raymarine type 1 hydraulic pump for sale

Boats with traditional hydraulic steering systems will use an Evolution autopilot driven by a hydraulic pump. The pump connects to the boat"s hydraulic steering lines and allow the autopilot to steer the boat by controlling the flow of fluid through the boat"s steering system. The hydraulic pump is controlled by the Evolution autopilot Actuator Control Unit (ACU.)

Raymarine evolution systems accommodate hydraulic, mechanical and power assisted stern drive systems. The Drive unit is the part that interfaces with your vessel’s steering system to keep you on the right course. Raymarine has a broad range of drive units to match almost any type of steering system. Raymarine Evolution pilots connect to hydraulic steering systems using a rugged hydraulic pump matched to the capacity of the hydraulic steering system. If your system is hydraulic You’ll need to find out the size (in cc) of the hydraulic cylinder ram(s) mounted to the rudder or inboard engined boats, or to the drive unit on outboard engined boats. Your steering system documentation will have this information.

12V 67 in/min Hydraulic Pump (M81120) by Raymarine. Type: 1. Fits Cylinder Capacity: 4.9 - 14 in. Peak Flow Rate (No Load): 67 in/min. Raymarine Evolution pilots connect to hydraulic steering systems using a rugged hydraulic pump matched to the capacity of the hydraulic steering system. If your system is hydraulic. You"ll need to find out the size (in cc) of the hydraulic cylinder ram(s) mounted to the rudder or inboard engine boats, or to the drive unit on outboard engine boats. Your steering system documentation will have this information.

In some systems with dual steering rams in parallel, cylinder capacity is the total of both rams. Rams in series only require single capacity valve. Hydraulic steering systems with steering rams over 500cc require larger constant running pump used in conjunction with the relevant ACU.

The Type 1 hydraulic reversing pump, 4.9-14cu.in. is a component for Raymarine SmartPilot autopilot system. Designed for boats with existing hydraulic steering systems. To match the drive of your vessel, you need to know the size of the actual hydraulic cylinder RAM or RAMs that are mounted to the rudder on inboard engine boats or the RAM mounted to the drive on outboard engine boats.Best UsePowerboats

This is a replacement motor for the newer style type 1 hydraulic pumps with the fittings coming out horizontal (if the motor was on a table.) WILL NOT WORK WITH OLDER M81120, only the newest style as is depicted in the pictures in the manual. This comes as shown. NOT A COMPLETE AUTOPILOT PUMP – just a replacement motor assembly.

If your system is hydraulic.. You"ll need to find out the size (in cc) of the hydraulic cylinder ram(s) mounted to the rudder or inboard engined boats, or to the drive unit on outboard engined boats. Your steering system documentation will have this information.

In some systems with dual steering rams in parallel, cylinder capacity is the total of both rams. Rams in series only require single capacity valve. Hydraulic steering systems with steering rams over 500cc require Raymarine"s larger constant running pump used in conjunction with SPX and SPX-SOL course computers.

Raymarine Evolution pilots connect to hydraulic steering systems using a rugged hydraulic pump matched to the capacity of the hydraulic steering system. To calculate the drive unit needed, you will need the size (in cc) of the hydraulic cylinder(s) mounted to the rudder or inboard engine, or the drive unit on your outboard. Info on which drive is right for you is available in the downloads section below. Alternatively if you know the brand and model of the hydraulic cylinder, click the cross reference chart in the downloads section

El Capitan Marine & Fishing Center has been providing the fishing community in South Florida with tackle and accessories since 1973. If we don"t have it, we can get it. If we can"t get it, you don"t need it.