split flow hydraulic pump in stock

ONE Dynex pump can supply multiple actuators, and synchronized movement can be achieved without flow dividers. Dynex pioneered this Split-Flow® technology over 60 years ago!

The checkball pump design uses individual piston check valves, offering a unique advantage among hydraulic pumps. Each pumping chamber can be isolated, and the output from each piston can be used separately.

For lifting and lowering applications on multiple points, Split-Flow Pumps are a far better alternative than using independently operated pumps. Where synchronization of maximum 4% is acceptable, Split-Flow Pumps are a safe and economical solution.

Combination of VE43D/VP43D and overcenter valve OC Over-Center Valve (OC): The overcenter valve (counterbalance) is designed to control the movement of the cylinder subject to a negative load. This valve is suitable for double effect or oil return cylinders only. The overcenter valve permits a controlled lowering phase of the load avoiding danger for the operator and for the hydraulic system itself. The valve is set to factory values, no reguation needed by the operator. The unidirectional flow control valve (RFUA) is a cheaper alternative to the overcenter valve: in this case, the operator must shut the valve before the lifting phase, to gradually open it during the lowering phase to set the return’s speed. This is obviously a cheaper way to obtain speed control during the lowering phase but the operator is exposed to danger due to a less accurate management of the load. Assembled on a split flow pump, the overcenter valve allows a fine control on the lowering phase too.

Since 1910 Enerpac has had decades of experience developing hydraulic systems and technology. Their products have moved some of the largest structures on earth. They are committed to achieving a Goal of Zero harm to their products" employees, customers, and end users.

Enerpac® Electric Hydraulic Pump, Split Flow, 9240 cu-in Reservoir, 15 hp, 153 cu-in/min, 10000 psi, 460 V, 60 Hz, 44-1/2 in Overall Length, 23.8 in Overall Width, 54 in Overall Height

For lifting and lowering applications on multiple points, Split-Flow Pumps are a far better alternative than using independently operated pumps. Where synchronization of maximum 4% is acceptable, Split-Flow Pumps are a safe and economical solution.

Enerpac model AM41 seven port split-flow valve enables control 2-4 single-acting cylinders simultaneously. All ports 3/8″-18 NPTF, maximum 10,000 PSI.