walking floor hydraulic pump supplier

1" Male and Female Wingnut Style Couplers W/dust cap and plug. Contact us for other size couplers. Includes Beiler Hydraulics Coupler Bracket - allows for quick and clean installation of the quick coupler.

This kit includes all the parts needed to install a wetline for operation of a walking floor® trailer, excluding the hoses and tank.Click Here to add the tank to your order. Please Contact Us when your wetline is installed to order the hoses - this allows us to send you the correct hose lengths.

This is the black CleenSweep (Clean Sweep) hydraulic motor only numbered 20 in the diagram. The second picture shows the diagrammatic layout only. We can supply the whole assembly as a separate part.

First and foremost: make sure the rear doors and the top sheet are both open before you activate the moving floor system! Other than this, there are 5 steps to make sure you’re using your walking floor trailer in the best possible way.

First, you need to make sure the hydraulic hoses and electric cables are connected correctly. There is a pressure supply hose (P) and a return-to-tank hose (T), NEVER reverse these two hoses as there is a risk of damaging the moving floor system and/or the pressure pump.

Make sure your hydraulic pressure pump is set to “high pressure”. For the best performance, the PTO pump should deliver between 90 – 110 liters per minute at 225 bar. If you have to adjust the pressure, have a look at the manual provided by the manufacturer of the truck and/or PTO system or contact your local STAS dealer to do this for you. When everything is set, continue to step three.

The electronic circuit to control the moving floor system draws electricity from the lighting circuit of the trailer. This means the control system won’t work if the lighting isn’t switched on. Turned on the lights? Go on to step four!

Check to see if your remote control is connected to the walking floor system. STAS delivers all new vehicles with an already connected remote control. Once the remote control is connected, you can skip this step as the system will automatically connect in the future.

Now you’re in the know of how best to use your walking floor trailer, congrats! You can use the remote control or the cable control box. While unloading, shut down the PTO from time to time. Release the handbrake and drive a little bit forward to release the force of the unloading process. Restart the procedure until the moving floor trailer is completely emptied.

With a payload capacity of up to 30 tonnes, artic tippers can be super-productive. Fitting a HARSH Hydraulic Tractor Wet Kit adds considerably to that performance potential.

Whether PTOs, pumps, valves or hoses, HARSH Tractor Kits are built to the highest manufacturing standards and offer complete component compatibility. In turn, they are perfectly suited to all the latest EURO 6 engine and gearbox specifications.

HARSH Tractor Wet Kit hydraulic circuits are built to suit single, dual or any other variation of hydraulic power you require to run your trailers. For example, walking floor, tipper, crane, ejectors, low loaders, tankers and other bespoke applications.