wd45 hydraulic pump adjustment quotation

I am trying to adjust the hydraulics on my 45. It has no lifting power. On step #1, you screw in the lower screw. WHAT do you screw this into?? Then step #2 screw in to the body to separate the plates. The only step I am having trouble with is step one. WHAT do I screw this into? It says the body, but when I move the lever it tends to slide down.

Ted, You may want to check the pressure on your pump. Should be around 3300 psi. If not then it is an internal job. May have problems with pressure release or leaking o rings valves.

Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B Misc other equipment that my wife calls JUNK!

Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B Misc other equipment that my wife calls JUNK!

I know there is lots of things to adjust on the pump, I tried setting the traction booster system to plow one time, I only had a 3 acre field and never did get it right. the plow was in and out like a feeding porpoise.

The linkage for the feedback from the snap coupler is missing, and I have dialed out the traction control and set the other adjustments acording to the manual. But it still creeps up.

Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B Misc other equipment that my wife calls JUNK!

Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B Misc other equipment that my wife calls JUNK!