williams model 30 hydraulic pump quotation

Here at Northern Hydraulics, we stock hydraulic pumps, piston pumps, hydraulic valves, and reservoirs manufactured by Williams Machine & Tooland Energy Manufacturing.

Williams Model 40 Pump Flow 3.7 GPM 14 LPM @ 1000 RPM - Displacement/Revolution 0.9 cubic inches 14.7cc - Maximum Pressure 3500 PSIG 240 bar - Drive speed range 300 to 1000 RPM - Maximum drive speed 1000 RPM - Bi-al - Input Shaft 1" 2.54mm, keyed - Replacement Pump for 40 Series Bailey No. 250-542

Compact, reversible and completely self-contained. Pump, reservoir and control valve are all in one unit. Efficient over a wide pressure range and temperature range. Flow is constant, even at low RPM. High contamination tolerance. Features steel intake and exhaust valves, which extend pump life 3-5 years over cast iron seats. Hardened steel spool valves are honed and hand-fitted. May be operated from a remote position with wire control cable. 1"" hardened steel shaft is supported on front and rear by heavy duty needle bearings. Heavy gauge, hot rolled steel reservoir with filler pipe filter. 4-way control valve.

Hydraulic pumps are mechanical devices that convert mechanical energy into hydraulic energy. They generate flow with enough power to overcome pressure induced by the load. Hydropack offer group 30 external gear pumps with different specifications.

So I tore this off our old Viking chevy truck. It"s from a Swartz hoist install but it says Williams on the tank. Dad found the owners manual from when it was installed in the eighties which was pretty neat. It"s got a built in pressure relief valve and a double acting spoil valve. I"m thinking I should be able to just install a splitter valve and be able to run bed and hydraulic drill fill? Looks like a one inch shaft so hooking up a 12 horse or so Honda shouldn"t be difficult.