wiring diagram for 12v hydraulic pump in stock

Here are some Details of diagram,12vdchydraulic circuit diagram and electrical diagram. And more, AHydraulic Power Pack.This Wireless Remote can be with a quick connector ,can be changed with our standard 2 buttons remote easy since the quick connector is on the power pack.

a)  Press the up button on the hand held remote pendant, to run the trailer bed up 1/3 of the way up. While running the bed up view the hydraulic fluid through the breather cap opening, you may see the fluid returning into the tank. If you see any air pockets or aera- tion of the fluid, please stop and allow the fluid to settle and continue to raise 1/3 of the way up.

a)  While running the bed up view the hydraulic fluid through the breather cap opening, you may see the fluid returning into the tank. If you see any air pockets or aeration of the flu- id, please stop and allow the fluid to settle and continue to raise 2/3 of the way up.

a)  While running the bed up view the hydraulic fluid through the breather cap opening, you may see the fluid returning into the tank. If you see any air pockets or aeration of the flu- id, please stop and allow the fluid to settle, and then continue to raise the bed to the end of the stroke.

With the cylinder fully retracted, remove the Filler/Breather Cap and fill the reservoir with hydraulic fluidto “Full Line,” (see fluid recommendations).

Connect the Positive cable from the battery to the start solenoid (Diagram A-5).(Please see Battery Cable Gauge table for proper gauge for your length of cables.)

Pull the valve out of the pump and clean with parts cleaner as well, flushing the block. The cleaner will flow out of the tubes into your collection bucket.

Reassemble pump, reconnect hoses, and fill the reservoir with AW46 (hydraulic fluid) or Dexron III (automatic transmission fluid) and purge the system until it’s full. Be sure NOT to mix the two fluids. Only use one type.

First, Make sure your solenoid is properly grounded.  To ground the solenoid, run a small 14 gauge ground wire from the ground on the pump to the screw mounting the solenoid to the motor.

Using a jumper wire, (14 gauge wire 10” long  with alligator clips on both ends is easiest) jump from the 12V terminal on the solenoid to the activator post (the small post). You should hear a faint click.

With a 12V test light, check to see if you have 12V on the copper terminal that connects the solenoid to the motor (usually looking from the rear the copper terminal on the right). If you do have 12V, the solenoid is good, if not the solenoid needs to be replaced.

Step 2. Check your wiring. Loose, frayed, and especially corroded wires can prevent your equipment from getting adequate power, and even damage your electrical parts.

Step 3. To lower your spears, you will need two wires. Both wires will connect to the hot post on your solenoid. The end of one wire needs to connect to the plastic coil on the side of your pump.

HYDRO-PACK LTD is dedicated to engineering, manufacturing, warehousing and distributing fluid power products located in “City of Roses” Kazanlak, Bulgaria and has business connections on all over Asia, Europe, Middle East and Africa in hydraulic field. We carry on the activity under Hidros Group, Turkey and branch offices in Turkey, Germany and South Africa. Our wide product range includes hydraulic gear pumps, directional control valves, hydraulic valves, hydraulic motors and steering units, hydraulic power units, oil coolers, pump over gears, slewing drives, piston pumps, tractor and forklift replacement parts. We export our products to more than 60 countries.